HabboLand - Wired Guide - Ban Users From Room

aaron

‎

439posts

115likes

IDash!

Want to prevent people from being able to enter your room in the first place? Follow the steps below so you never have to manually ban someone again!

1x WIRED Variable: User Variable
1x WIRED Variable: From Another Room
1x WIRED Effect: Kick User
1x WIRED Effect: Give Variable
1x WIRED Condition: Has Variable
1x WIRED Trigger: User Enters Room
1x WIRED Trigger: Repeat Effect
1x WIRED Selector: Users By Name
1x WIRED Selector: Remote selection

In a seperate room, place your WIRED Variable: User Variable.

Enter a variable name, for example, user_banned
Select Permanent, shared across rooms.

In your main room place WIRED Variable: From Another Room

Enter the same variable name you entered in step 1 (user_banned)

Select the room your variable is in

Select the reference from the first room.

Make sure 'Read-Only' is not ticked.

Your next stack will be:

WIRED Trigger: User Enters Room

WIRED Condition: Has Variable

WIRED Effect: Kick User

In the Kick user wired, enter a message that will be shown to the user when they are removed from the room.

In the Has Variable wired, select the variable you have been using (User Banned).

If you don't see it, make sure the middle option is toggled above it (User).

'All match' should be selected as well as 'Use the triggering user' under Variable source.

User Enters Room needs no adjustment.

Place a WIRED Selector: Users By Name. Depending on the amount of users you want to add, you may need to add more.

All you need to do with this one is enter the names of the users you want to ban from your room. One name per line.

The final stack will be:

WIRED Trigger: Repeat Effect

WIRED Effect: Give Variable

WIRED Selector: Remote Selection

In Remote Selection, make sure it's set to:
Union
Use all selected Wired Stacks

Select all of the Users by Name Wired from the previous step.

In Give Variable, select the variable you have been using (User Banned). If you can't see your variable, make sure Read-Only isn't ticked from step 2.

Make sure Override existing variable is not ticked and Variable destination is set to 'Use users from selector'.